Fujitsu Siemens Computers FMW51BC2 User Manual

58-0581-01.fm Page 1 Tuesday, August 21, 2001 9:28 AM  
F u j i t s u P C C o r p o r a t i o n  
External Battery Charger  
User’s Guide  
FMW51BC1 / FMW51BC2  
PenCentra 130 / PenCentra 200 / Stylistic LT  
Stylistic LT C-500 / Stylistic LT P-600  
I N S T R U C T I O N S  
This external battery charger allows you to charge two  
battery packs. When two battery packs are installed, the  
pack installed first is charged first.  
Caution  
UL Notice:  
FMW51BC1 / FMW51BC2 External Battery Charger  
This battery charger is compatible with the following  
battery packs:  
I
FMW51BP1 battery pack  
I
FMW29BP2 battery pack  
I
FMW29BP1 battery pack  
I
FMW43BP2 battery pack  
I
FPCBP48 battery pack  
58-0581-01.fm Page 3 Tuesday, August 21, 2001 9:28 AM  
Table 1: Status Indicator States  
Indicator  
Condition  
Status  
Power  
OFF  
AC Adapter not  
connected  
Green/ON  
OFF  
AC Adapter connected  
No battery installed  
Charge complete  
Charging  
Battery 1/  
Battery 2  
Green/ON  
Amber  
ON  
Blink  
Standby (Waiting to  
charge)  
1
Red  
ON  
Battery pack alarm  
1
Blink  
Battery charger alarm  
1
If the battery charger indicates a fault condition with the battery  
pack, remove the battery pack, disconnect power to the  
charger, and contact your local help desk or your reseller for  
further assistance.  
3
58-0581-01.fm Page 4 Tuesday, August 21, 2001 9:28 AM  
Status  
Indicators  
Power  
Battery 1  
Battery 2  
1
2
Slide  
Connector pins  
Battery slot 2  
Battery slot 1  
DC  
input  
Rechargeable  
battery pack  
Figure 1. External battery charger  
4
58-0581-01.fm Page 5 Tuesday, August 21, 2001 9:28 AM  
Operational Considerations  
Issues to consider when you use the FMW51BC1 or  
FMW51BC2 battery charger are discussed as follows:  
I
You can insert up to two battery packs at a time in the  
battery charger. When charging two battery packs, you can  
insert or remove either battery pack independently.  
I
The battery charger only charges one battery pack at a  
time. When two battery packs are inserted in the charger,  
the battery pack installed first is charged first.  
I
The battery charger will indicate a full charge level and  
will not begin charging the battery pack if the battery pack  
charge level is 90% or higher when the battery pack is  
initially inserted in the charger. This prevents the battery  
pack from being overcharged.  
I
When you remove the battery pack from your pen tablet,  
always insert a charged battery pack in the pen tablet to  
replace the one that you removed, or apply DC power.  
I
The FMW51BP1, FMW29BP1, FMW29BP2, FMW43BP2  
and FPCBP48 battery packs use lithium ion battery cells  
which have no “memory effect.” You do not need to com-  
pletely discharge or “condition” the battery pack before  
charging.  
Battery Pack Charge Time  
The approximate maximum amount of time needed to  
charge a fully discharged battery pack to the 90% level is  
shown in the following table. Note that when two battery  
packs are installed in the charger, they are charged sequen-  
tially (starting with the battery pack that is installed first).  
5
58-0581-01.fm Page 6 Tuesday, August 21, 2001 9:28 AM  
Battery Pack  
FMW51BP1  
Approximate Charge Time  
3-cell  
<2 hours  
<2 hours  
FMW29BP2  
FMW29BP1  
FMW43BP2  
FPCBP48  
6-cell  
6-cell  
6-cell  
<3.5 hours  
<3.5 hours  
<2.5 hours  
FCC Notice  
This equipment has been tested and found to comply with the  
limits for a Class B digital device, pursuant to Part 15 of the FCC  
rules. These limits are designed to provide reasonable protection  
against harmful interference in a residential installation. This  
equipment generates, uses, and can radiate radio frequency  
energy and, if not installed and used in accordance with the  
instructions, may cause harmful interference to radio  
communications. However, there is no guarantee that  
interference will not occur in a particular installation. If this  
equipment does cause harmful interference to radio or television  
reception, which can be determined by turning the equipment  
off and on, the user is encouraged to try and correct the  
interference by one or more of the following measures:  
• Reorient or relocate the receiving antenna.  
• Increase the separation between the equipment and receiver.  
• Connect the equipment into an outlet on a circuit different  
from that to which the receiver is connected.  
• Consult the dealer or an experienced radio/TV technician for  
help.  
Changes or modifications not expressly approved by Fujitsu PC  
Corporation could void the user’s authority to operate the  
equipment.  
6
58-0581-01.fm Page 7 Tuesday, August 21, 2001 9:28 AM  
7
58-0581-01.fm Page 8 Tuesday, August 21, 2001 9:28 AM  
5200 Patrick Henry Drive  
Santa Clara, CA 95054  
For more information, visit our Web site  
For technical support call:  
1-800-8Fujitsu (1-800-838-5487)  
or e-mail us at: [email protected]  
Fujitsu and the Fujitsu logo are registered trademarks of Fujitsu, Ltd. Stylistic is a  
trademark of Fujitsu PC Corporation. All other trademarks mentioned herein are the  
property of their respective owners. We cannot guarantee the accuracy of the contents of  
this document. We disclaim liability for errors, omissions or future changes.  
© 2001 Fujitsu PC Corporation. All rights reserved.  
FPC58-0581-01  
8

Brother MFC 7360N User Manual
Canon PIXMA MG5420 Photo All in One Printer 6225B002 User Manual
Canon Wireless Photo All In One 8333B002 User Manual
Carrier 50DP016 User Manual
Daewoo DPB 280LH User Manual
Friedrich 42 User Manual
Honda Automobiles Tonneau Cover 4D16050S User Manual
Honeywell HZ 615 User Manual
HP Hewlett Packard Hewlett Packard All in One Printer P1000 series User Manual
HP Hewlett Packard J3600 User Manual